Better decisions before equipment is fitted
Suitability checked first
We assess insulation, space and emitters before recommending a system.
Hot water included
We plan storage and demand rather than treating hot water as an afterthought.
Supported equipment
We select higher-end products for stronger backing if a unit develops a fault.
Check the property before choosing the pump
An air source heat pump can provide lower-carbon heating, but good performance depends on the building and system around it. We assess heat loss, insulation and outdoor space before recommending equipment. The position of the outdoor unit affects access and operation, while radiator or underfloor heating sizes affect the temperatures the system needs. We also plan hot-water storage and controls. This design work shows whether the property is suitable and what supporting changes may be needed before the heat pump is installed.


Equipment backed by stronger support
We favour high-end heat pump equipment with stronger manufacturer backing and replacement support if the equipment fails. Typical customer spend is around 10,000 to 12,000 pounds, although the final quotation depends on the property, emitters and hot-water design. We install the agreed system, set up the controls and explain how steady, lower-temperature heating differs from a boiler. A correctly designed and operated system may reduce energy use and carbon impact, but we don't promise a fixed saving.
Frequently asked questions
Will an air source heat pump suit every property?
Not always. Insulation, outdoor space, heat loss and the size of radiators or underfloor heating all matter. We assess these points first and explain any changes needed for the system to work as intended.
How much does a heat pump installation cost?
The stated typical spend is around 10,000 to 12,000 pounds. Property heat loss, hot-water storage, emitter upgrades and installation access can change the final figure, so we prepare a quotation after an assessment.
Will a heat pump lower our energy bills?
It may reduce energy use when the building, emitters and controls suit lower-temperature operation. Actual costs depend on the property, energy tariffs and how the system is used, so we avoid promising a set saving.

